Enabling it should improve network performance to a useable level. The rt2860 module is included in the 2.6.39 kernel. Now reboot your system and start using the new module. Edit the module blacklist: $ sudo nano /etc/modprobe.d/nf Now you should blacklist the other RT modules. $ sudo add-apt-repository ppa:markus-tisoft/rt3090 In my case, Ubuntu would no longer shut down, but there are many positive stories about the module too.įirst, install the package from the Markus Heberling’s personal package archive. If you are running Ubuntu, this module might give better results than rt2860. To see your currently loaded kernel modules: $ lsmod | less I have yet to test the RT3090 with the 3.0 kernel. If you are running Ubuntu, you can try the rt3090-dkms package, which might give better results than the rt2860sta module.ĮDIT: Apparently the rt2860sta module was removed in version 3.0 of the Linux kernel, and replaced by the general-purpose rt2800pci module. The included-by-default kernel module that seems to give the best results with the RT3090 is called rt2860sta. If you are having lots of wireless networking problems, you probably don’t have the correct modules loaded. The Linux kernel decides which modules (drivers) should be loaded for your hardware setup, but it can get it wrong. These problems manifest themselves as a connection that is unreliable and slow or even completely broken. If you have a Ralink 3090 (RT3090) wireless network card, you can run into problems when running Linux.
0 Comments
Leave a Reply. |